Help Need To Set Up Net Work At Home Options

[2007alain2007]

Hi I am new and can not spell that good but i try my best

here gos i have two pcs one with xpSP2 and the other with vista i am trying to net work them and i have buyed a net work card for the xp pc it is a Optronix op-125 MX 98715 lan card and i put it in to the pc in slot one and it say i have to:


How to Config Your PCI adapter.
-------------------------------
1. Firstly , you must find the PCI configuration item in BIOS setup.

2. There are some key points you must take care of.

a). You should know what slot your adapter plug in. You can find the
slot number in your mother board or its operating menu.

b). Enable this device.

c). Enable "master" this item.
The Macronix MX987xx Family Fast Ethernet Adapter MUST be installed
in a bus master PCI slot. Refer to your system documentation to
determine which slots support bus mastering.

d). You can choose what interrupt line you used in some BIOS setup.
For MXIC' adapter, you must choice "INT A" in this item.

e). Choose what interrupt number you want. You can assign it in what
interrupt you choose or in the slot number you choose.

3. When you finish your configuration. You can run the diagnostic program
in the driver diskette. If any problem, please contact your dealer.

in the read me but i do not know the ins and outs of the BIOs is there a slot that it has to be in or can it be in any please help

and this is what happons on the diagnostic program it says no any pci ethernet card in this system

This post has been edited by 2007alain2007: Apr 23 2008, 05:23 AM

[whitehat]

First welcome,

second.... it sound like you are running a older machine. What type of hardware are you running exactly so I know what I am dealing with. did you look in device mangler and make sure that the card isnt seen and its just not the driver.

Whitehat